Page 1 of 1

Syntor x cable question

Posted: Tue Jun 02, 2020 1:00 pm
by JCC419
I have a syntor x model t45vbj7000bk with a systems 90 8 channel control head.
Hnn4008 . The problem encountered was the green 12 volt wire broke from the pin
On the black connector . I don't own a manual for this radio . The closest thing I found
Online that it's suppose to connect to pin #12 and it's showing an orange 12 volt switched
Wire on pin #13 which I don't see . My question, are both these power sources required to
Get 12 volts to the control head ? also , does this type of control head use a ground wire ?
If anyone is familiar with syntor x cabling I would appreciate any help.

Re: Syntor x cable question

Posted: Thu Jun 04, 2020 5:37 am
by fineshot1
You will need these below pins and removal tool but not even sure if these parts
are still available.

Contact Pin Removal Tool part number - 66-84690C02 and Contact Pins (package of 5) - part number 09-84151B03

Re: Syntor x cable question

Posted: Thu Jun 04, 2020 11:15 am
by Karl NVW
And to answer the 2nd part, NO, your radio does not need the orange lead unless you will be transmitting. Green lead fed from +13.8 battery, orange from Ign Switch 13.8 VDC. Ground is returned back to the radio drawer within the control cable - helps keep ignition noise out of the optional accessory channel scan logic board above the control head.