GM300 Programming Problems (Part 2)
Posted: Sat Sep 21, 2002 1:43 pm
OK, I have the computer that is needed and DOS 6.22 is the only thing on it other than my GM300 RSS. When I try to read the radio it says:
Accessing Serial Bus...
then:
Serial Bus Error:
#2 - No Acknowledge
The radio is on and powered just fine. Do I have to put it in programming mode somehow? I tried to switch the computer setup to the other port but that didn't work either. The RIB and cable work too...
What do I do???
Thanks,
Dereck
Accessing Serial Bus...
then:
Serial Bus Error:
#2 - No Acknowledge
The radio is on and powered just fine. Do I have to put it in programming mode somehow? I tried to switch the computer setup to the other port but that didn't work either. The RIB and cable work too...
What do I do???
Thanks,
Dereck