O9 APX7500 V&7/800 w/ HLN1439D Siren

[TXCAP]

Any on here know if there is a way to completely or close to completely lower the Ext. Radio & PA Functions.
It seems that the Volume for the EXT. Radio just doesn't go low enough for the officers comfort.

Using V9 Firmware & R09.00.01 CPS

[spectragod]

You adjust the outside volume via the volume control on the radio or the volume control on the siren you are using for rebroadcast. Why in the world are you using 9.0?

[Mfire39]

Why in the world are you using 9.0?

Unless I completely missed it, R09.xx is current.. Is there a newer version for APX that you're aware of?


-Marc

[spectragod]

Why in the world are you using 9.0?

Unless I completely missed it, R09.xx is current.. Is there a newer version for APX that you're aware of?


-Marc

I must have been asleep when I posted that, because for some reason I thought he was referring to a xtl, not an apx, I do think 9.02 is out, I'd have to check MOL, but I am sure that you are more right than me.... thanks for the heads up.

[TXCAP]

Been there done that... I too have been "Asleep at the keyboard" SG...


As for the Issue With APX we used to be able to completely lower the PA & Radio Re-Broadcast on the Ol' Astro Spectra's & XTL's (W9 Heads).

But with the APX7500, even if I set the Preset PA Volume to 0 (Zero) (O5 or O9 Head) it is still too loud (Even if we manually lower both PA & RRB to 0 when active), just seeing if anyone else has seen this.

[mhodgson]

I have two of the same setups and no better luck.....guessing it will be no different on the 07 either.

Mike

[Pj]

Using FW11, if I lower the vol to 1, seems ok. You also have to remember for intelligible audio with such siren speakers and all that electrical jazz, there needs to be a minimum audio output to not have the audio get distorted. Digital audio sounds worse than analog in my case, but when at "1", it works nicely.