Batboard

im bored on disability. need to know what bit to use for change a9 head to a7 in bit banger. i know the location.

change the model number from a9 to a7 on the MLM and Command board
then change ox6060 to ed
read the info on Batlabs model specific page
and good info at RBTIP

kb9rre wrote:im bored on disability. need to know what bit to use for change a9 head to a7 in bit banger. i know the location.

Depending on which version of the programming software you have, there is a selection to get into the bit banger and go into specific addresses to change some of the features. There are some documents available that tell you what addresses to go to and what to change them to to set up the different selections.

I sent you a message with my email address to contact me and I can send you the documents with the info.

Jim