MTR2000 900 Low Audio
Posted: Mon May 09, 2022 11:09 am
Just picked up a MTR2k 900, which was originally part of a smartnet trunk system. I programmed it into the ham band, as a stand along repeater.
It receives fine, however it does not have very much TX audio. only about .800Khz deviation.
I also tried to use the rear accessory connector with my allstar node, which has been working on my UHF mtr, same results. very low audio.
I did go into the service menu, and brought up the rear input level, but didn't have any effect.
Any thoughts on getting it to work?
I did try to program it into the native commercial band, still low audio.
Dirk
It receives fine, however it does not have very much TX audio. only about .800Khz deviation.
I also tried to use the rear accessory connector with my allstar node, which has been working on my UHF mtr, same results. very low audio.
I did go into the service menu, and brought up the rear input level, but didn't have any effect.
Any thoughts on getting it to work?
I did try to program it into the native commercial band, still low audio.
Dirk