Page 1 of 1
motorola r2001a frequency counter it does not work
Posted: Tue Jul 31, 2018 10:42 am
by motomnbvc
Good morning I own a motorola r2001a, it works completely. The only problem that if I go on the frequency counter function does not read any frequency in the RF input. if I try in the connetor bnc vert \ sinad \ dvm \ frequency counter in then reads the input frequency. Can you help me? Thanks so much
Re: motorola r2001a frequency counter it does not work
Posted: Wed Aug 01, 2018 3:55 am
by jry
that is how it is supposed to work.
The RF inputs are just for "tuned" measurements.
Believe the manual is on repeater builders so I would look through the operations section of the R2001A manual. Do not think there was a separate OM for the A version.
The D version of the R2001 is almost a completely different unit and it did have a pretty decent OM that would apply at a high level.
A lot of the controls are different.
The frequency counter if a relatively low frequency counter ( like audio ranges ) IIRC
Re: motorola r2001a frequency counter it does not work
Posted: Wed Aug 01, 2018 5:22 am
by motomnbvc
Re: motorola r2001a frequency counter it does not work
Posted: Thu Aug 02, 2018 3:31 am
by kcbooboo
Once you've set the operating frequency correctly on the screen, the carrier frequency ERROR, of an RF signal applied to the RF IN/OUT N-female jack, can be viewed on the MONitor display along with deviation.
To use the frequency COUNTER, you need to feed the signal into the separate Vert/Sinad/DVM/Counter BNC-female jack, and it covers 10 Hz to 35 MHz. These specs are in section 1 of any of the R200X manuals.
You can't apply an RF signal to the R2001 and have it tell you the frequency, like you can do with a stand-alone frequency counter (annoyingly). You need to know in advance what frequency it's supposed to be, or use a scan function to locate it.
Bob M.
Re: motorola r2001a frequency counter it does not work
Posted: Thu Aug 02, 2018 3:40 am
by motomnbvc
OK thanks. in the manual it is written that you can not apply a rx in bnc Vert / Sinad / DVM / Counter. but we must use the input re in out