R2660B Hangs when selecting Spectrum Analyzer Display
Posted: Sat Mar 09, 2019 10:23 am
I have a R2660 that seems to work on gen or monitor but locks up when either the Spectrum Analyzer, or tracking generator is selected. At that point it does not respond to any keypress or control change until power cycled. Had leaky battery on processor board which was removed and contaminated areas cleaned. Would not power up when received. Shorted diodes in the -12V supply section were replaced.
Any suggestions on how to proceed in problem isolation/elimination? Thanks in advance!
Any suggestions on how to proceed in problem isolation/elimination? Thanks in advance!