Motorola R2670 boot screen

This forum exists for the purposes for discussing service monitors (This includes but is not limited to Motorola, HP, Aeroflex, GD, etc). Additional topics allowed include test procedures, interpretation of test results, where to find information about specific tests, antenna VSWR, return loss testing, duplexer and filter alignment, etc.

Moderator: Queue Moderator

Post Reply
sparktastic
New User
Posts: 11
Joined: Wed Dec 21, 2011 12:34 pm

Motorola R2670 boot screen

Post by sparktastic »

Hi Motogurus,

Does anyone know if there is a way to store the boot screen configuration in the Motorola R2670?

I recently had to repair the switchmode power supply and replace the memory backup battery in my unit.

After a self cal, the unit works fine, but now when I power up and the unit goes into Monitor mode, on the last used frequency,
the Display section reverts to Modulation scope instead of spec analyser (as was the case before).

Is there a way to set the default boot display to Spec analyser?

I note that memory locations 33 to 44 are labelled 'Factory Default'. Is one of these a boot config??

Thanks guys :)
sparktastic
New User
Posts: 11
Joined: Wed Dec 21, 2011 12:34 pm

Re: Motorola R2670 boot screen

Post by sparktastic »

Disregard....

Found it in the SPF (Special Functions Menu) menu, under System Functions & then 'Save State'.
Post Reply

Return to “Test Equipment & RF Equipment Alignment”