ROIP with CM300

This forum has been created to foster the discussion on future and cutting edge technology. This discussion is not limited or restricted to Motorola. Examples of allowed discussion are open source hardware (GNU Radio for example) and software (Open source P25, Asterisk, ROIP, etc). Discussion is also permitted where older technology could be applied to areas where it had previously not been used (Example: Trunking on amateur radio).

Moderator: Queue Moderator

Post Reply
New User
Posts: 1
Joined: Wed Apr 29, 2015 10:41 am

ROIP with CM300

Post by pdwood »

Hello folks.
Had a question for you about roip and hooking up to a CM300 UHF Mobile.

I currently have a RT-ROIP Box that works great with HT but I am having trouble getting it to work correctly on the mobile. This ties into the Zello app very well.

Keying on the RX freq that the mobile is tuned too will send the signal to zello with out any worries. RX on the mobile to the interface box to the zello app.

Now the issue is if you are using zello or skype and key up the app on your smart phone the interface box see the signal but will not key up the mobile. When the HT is hooked up to the interface works well.

My guess is that the radio would need to be set up as if you were doing a cross band link. How would you set that up in the programming file for the cm300?

Thank you,
Paul Wood
Posts: 6823
Joined: Tue Sep 04, 2001 4:00 pm

Re: ROIP with CM300

Post by Will »

Have you checked that the CM300 accessory connecter is programed correctly?

RX audio needs to come off RX Filtered pin. TX mic source and PTT need to be set.
New User
Posts: 6
Joined: Wed Jan 14, 2015 12:46 pm

Re: ROIP with CM300

Post by HWRTcomm »

Hi, We recently got the same RT-ROIP box and wish to use it with the CDM1550. Is the default setting for the pin out okay? or is there a certain way to set up the pins. If anyone has figured out the correct setting, could they share? Thank you much.
Post Reply

Return to “Experimental and Next Generation LMR”