Trying to connect a "NIB" HLN6911H Grey face O5 remote mount control head with a XTL5000 and I get a FL 05-93 code, regardless if the control head is connected to the brick or not. The radio had previously worked with an O5 control head, so I doubt it is in the brick. Plugged in a W7 head and could read the radio, info as follows:
DSP R19.50.01
Firmware R20.50.09
Software R20.01.00
Tried syncing the control head and the software could not open the USB port to the head. I am sure I am missing something obvious, any suggestions??
TIA
O5 FL 05-93 with XTL 5000
Moderator: Queue Moderator
-
Andy Brinkley
- Batboard $upporter
- Posts: 375
- Joined: Mon Sep 03, 2001 4:00 pm
- What radios do you own?: FMR80D and a Motrac with Scan
O5 FL 05-93 with XTL 5000
Andy / NC4AB
-
spectragod
- Posts: 2028
- Joined: Sun Dec 30, 2001 4:00 pm
- What radios do you own?: FPP 6 meter XTL 5K's
Re: O5 FL 05-93 with XTL 5000
TIB and CHIB must match, I’ll bet the CHIB is a later variant than the TIB, or vice versa.
Kilgore: Smell that? You smell that?
Lance: What?
Kilgore: Napalm, son. Nothing in the world smells like that.
Kilgore: I love the smell of napalm in the morning. You know, one time we had a hill bombed, for 12 hours. When it was all over, I walked up. We didn't find one of 'em, not one stinkin' dink body. The smell, you know that gasoline smell, the whole hill. Smelled like... victory. Someday this war's gonna end...
____________
Revelation 6:8
Lance: What?
Kilgore: Napalm, son. Nothing in the world smells like that.
Kilgore: I love the smell of napalm in the morning. You know, one time we had a hill bombed, for 12 hours. When it was all over, I walked up. We didn't find one of 'em, not one stinkin' dink body. The smell, you know that gasoline smell, the whole hill. Smelled like... victory. Someday this war's gonna end...
____________
Revelation 6:8
-
Andy Brinkley
- Batboard $upporter
- Posts: 375
- Joined: Mon Sep 03, 2001 4:00 pm
- What radios do you own?: FMR80D and a Motrac with Scan
Re: O5 FL 05-93 with XTL 5000
I should have marked this thread closed, the issue was the flex cable inside the control head was only connected on one end. The control head was NIB, so apparently this one slipped through Quality Control.
After plugging the cable in the head is now working fine
After plugging the cable in the head is now working fine
Andy / NC4AB