Page 1 of 1

Town & Country install

Posted: Thu Jul 18, 2013 7:03 am
by arlojanis
Where is the best place to make a hole to pass thru firewall in a new Chrysler town & country van?

Re: Town & Country install

Posted: Mon Sep 01, 2014 2:38 pm
by KC9MDQ
There should be a large grommet on the driver's side of the firewall, that's where I ran my coax and the power lead for the MaxTrac through.

Re: Town & Country install

Posted: Wed Sep 03, 2014 7:54 pm
by KC9MDQ
My T&C is a 2008, and I mounted my 32 channel MaxTrac in the cubby directly below the HVAC controls. I had to remove the entire center stack and unbolt the cubby from front face plat, after that it slid right in. If memory serves, the 2011 and up T&C's ( and Caravan's ) relocated the HVAC to a slightly different location, but I believe the grommet is in the same location. I'll try to post a picture of the grommet location in my van, that should at least give you a frame of reference.