Planning on using a 900MHz GTX as a control recever in the 926-927MHz range. Will it work OK for this? Where are the COS and PL Indicate points in the GTX radio for interface to the controller?
Thanks!
GTX 900 as Repeater Control RX ?
Moderator: Queue Moderator
- n_zero_ndp
- Posts: 330
- Joined: Mon Feb 25, 2002 4:00 pm
Re: GTX 900 as Repeater Control RX ?
I can't believe nobody has an answer to this one. I know somebody has access to the service manual out there, c'mon folksd119 wrote:Planning on using a 900MHz GTX as a control recever in the 926-927MHz range. Will it work OK for this? Where are the COS and PL Indicate points in the GTX radio for interface to the controller?
Thanks!
The EDACS DΩRK......
- n_zero_ndp
- Posts: 330
- Joined: Mon Feb 25, 2002 4:00 pm
thank you
A big thank you to everyone in the following thread to help shed some light on where to find COS on the GTX mobile:
http://batboard.batlabs.com/viewtopic.php?t=26607
http://batboard.batlabs.com/viewtopic.php?t=26607
The EDACS DΩRK......
- n_zero_ndp
- Posts: 330
- Joined: Mon Feb 25, 2002 4:00 pm
Looks like it is COS only...better than nothingd119 wrote:Nand:
Unfortunately that image isn't working anymore, can you post it again? And is this a PL/DPL controlled connection or COS controlled?
Thanks!
I will PM Nand about the pics link being down.
Nand wrote:It is a CMOS output that is high when a carrier is detected.
The EDACS DΩRK......