I would like to remove the vol knob from one M3 and install it on another M3. I can't figure out how to remove the knob. Can someone tell me the trick? If you have to open the case, I will just send it out. I always seem to break the case as I open it.
Thanks.
Minitor 3 knobs
Moderator: Queue Moderator
Minitor 3 knobs
"depending on your point of view, either the changing magnetic flux makes the electric field, or the changing electric flux makes the magnetic field- but you can't have one without the other"
I would recase the thing completly. The only real way to get the knobs off is to break them off. Usually in the process you do infact break something 
With this in mind, I have found that it's cheaper in the end to order a full case.
In the end, the shipping costs of getting more parts, paying tax, paying shipping, etc, it all just adds up too quickly.
New front housing should be like $12, and a rear housing around $8. Of course, they won't have lables on them, except for the Minitor IV/III.
-Alex
With this in mind, I have found that it's cheaper in the end to order a full case.
In the end, the shipping costs of getting more parts, paying tax, paying shipping, etc, it all just adds up too quickly.
New front housing should be like $12, and a rear housing around $8. Of course, they won't have lables on them, except for the Minitor IV/III.
-Alex
The Radio Information Board: http://www.radioinfoboard.com
Your source for information on: Harris/Ma-Comm/EFJ/RELM/Kenwood/ICOM/Thales, equipment.
Your source for information on: Harris/Ma-Comm/EFJ/RELM/Kenwood/ICOM/Thales, equipment.