MT-200 Failure Codes

w7ry · Post by **w7ry** » Sun Oct 14, 2001 11:33 am

I have a MT-2000 UHF radio that "says" Fail 01/92. This happened when I was doing an alinment. I have RSS for the radio and was able to read/program the radio before this happened.

Any assistance would be a great help.
Thanks
Jim

Post by **astroman** » Sun Oct 14, 2001 5:39 pm

I had the same problem with a radio last week
we used CPS software and it gave us the
err 01/92 so we went back to our DOS. software and pulled up a archive of the radio
and reprogrammed it and it works just fine now but we can not use CPS software to program it. SO try using DOS Base software.

w7ry · Post by **w7ry** » Sun Oct 14, 2001 8:13 pm

That is all that I have used is the DOS version.
Thanks for the input though.
Jim

Radioshop · Post by **Radioshop** » Mon Oct 15, 2001 9:26 am

Fail F01/92 is Internal EEPROM checksum error. Cause Bad internal codeplug data,(something missing or programed wrong) or Defective microcontroller.

Corrective action: Reprogram with saved working archive! or Clone from working archive. If this does not clear failure you could have a microcontroller failure which means factroy repair.. Most of the time when we see this failure we can clear it about 98% of the time by reprograming with the original working saved archive.