Flashing a Non-Digital AS3 UHF to a Digital AS3 UHF?

RTFireguy · Post by **RTFireguy** » Sun Mar 19, 2006 2:23 pm

Basicly I want to turn a Non Digital AS3 that i bought into digital.

How hard is it and also what is needed?

Thanks all.

jmr061 · Post by **jmr061** » Sun Mar 19, 2006 2:33 pm

You have to have the host/dsp upgraded to support IMBE and then have the options you want flashed into it. Not too many people can do the host/dsp change. Good luck.

Jason

K8TEK · Post by **K8TEK** » Tue Mar 21, 2006 2:57 am

Your host needs to be higher then R04.00.00 and dsp needs to be higher then N / I 06.00.00 to support IMBE. (A or M DSP is analog only)

Post by Pj » Tue Mar 21, 2006 10:34 pm

For the most part, your stuck with going to your local MSS and ordering the IMBE FLASHport upgrade kit.

This will run you about $600ish for the software and shop time for them to load the software into the radio. When this is done, the flash kit will upgrade your firmware.

RTFireguy · Post by **RTFireguy** » Wed Mar 22, 2006 12:06 am

Damn.