Anyone have an i20r manual I can borrow for a week or so?
Moderator: Queue Moderator
-
sglass
- Batboard $upporter
- Posts: 2282
- Joined: Sat May 18, 2002 2:03 pm
- What radios do you own?: sonic screwdriver
Anyone have an i20r manual I can borrow for a week or so?
I would greatly appreciate it.
Hey,
since you got one, can you tell me how to program the low voltage alarm.
I have programmed it already and works fine but the alrm comes with 11 volts limit and when the battery backup is with 11 volts you don't have current enough to make the TX work.
It works with the maxtrac and cm300 but the CDM series needs something like 11.5v to TX.
I would like to program to 11.5 volts.
Tks,
since you got one, can you tell me how to program the low voltage alarm.
I have programmed it already and works fine but the alrm comes with 11 volts limit and when the battery backup is with 11 volts you don't have current enough to make the TX work.
It works with the maxtrac and cm300 but the CDM series needs something like 11.5v to TX.
I would like to program to 11.5 volts.
Tks,
1. Press test button to put unit into diagnostic mode.
2. Press test button four more times to get to diag test 5.
3. Adjust battery voltage down to where you want lower setpoint.
4. Activate external alarm input(ext alarm function must be programmed into an input pin of PR5) - the rx radio connector - to allow setting low battery threshold.
2. Press test button four more times to get to diag test 5.
3. Adjust battery voltage down to where you want lower setpoint.
4. Activate external alarm input(ext alarm function must be programmed into an input pin of PR5) - the rx radio connector - to allow setting low battery threshold.