cdm trouble

jmr3865 · Post by **jmr3865** » Tue Aug 08, 2006 7:28 pm

I am having trouble with a few cdm's. When scanning channel 1 wide band and channel 2, narrowband, i have to turn the volume up on channel 2 in order to hear it. than channel 1 comes in two loud. I am constantly adjusting it. Any sugg? firmware?

jim · Post by **jim** » Tue Aug 08, 2006 7:36 pm

Someone elses levels aren't right if your spacing is properly set.

J.Sanor · Post by **J.Sanor** » Wed Aug 09, 2006 12:51 am

Try turning on the Companding feature for channel 2. This is supposed to improve the audio on narrow band channels

jmr3865 · Post by **jmr3865** » Wed Aug 09, 2006 7:47 am

i am using companding. 159.2175 is 12.5 right?

HLA · Post by **HLA** » Wed Aug 09, 2006 8:26 am

companding is only going to work right if everyone else has theirs on too.

thebigphish · Post by **thebigphish** » Wed Aug 09, 2006 9:21 pm

do you have (that gawdawwful) lowlevel expansion or the AGC on?

bellersley · Post by **bellersley** » Thu Aug 10, 2006 3:10 am

What is LLE supposed to do anyway? Anytime I have enabled it, the audio is terrible! And when I turn on AGC, it takes a second for the audio to come up it volume... Useless!

jim · Post by **jim** » Fri Aug 11, 2006 10:07 am

Turn off all "audio enhancers" that destroy audio quality.