MX2000: No TX Power after programming

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
rembrandt
Posts: 1
Joined: Wed Oct 31, 2001 4:00 pm

Post by rembrandt »

Hi,

after programming two MX2000 VHF (only changing one frequency) the TX works with about only a few milliwatts. But the power setting is "Std. RF Power per Radio high" as before.

While RSS writes the data into the radio the display shows "ERR 0 81", may this be the reason? I'm using RSS R02.00.00.

Does anybody know this strange behavior?
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”