VHF MCX1000 Alignment

w4rez · Post by **w4rez** » Wed Dec 20, 2006 2:55 pm

Is there a quick and dirty alignment procedure for the MCX1000? This one is tuned for 165-170 MHz and is therefore nearly deaf on 2m where I need it to be able to hear.

EPC_1111 · Post by **EPC_1111** » Thu Dec 21, 2006 10:37 pm

I have the service manuals, Ill look up the procedure for you. What are you trying to tune it to?

Jatla · Post by **Jatla** » Fri Dec 22, 2006 3:35 pm

I assume that you are looking for a work around the needing of an RF millivoltmeter and the right probe adapter? I am not sure there is a good way to get past this, unless a try and try again adjusting approach of the slugs with a signal generator into the antenna connector and comparing the sensitivity...this may be a very difficult road to hoe.