I need to attach several communications grounding buss leads to building steel. Have cad weld, know how to use it.
Here's the problem: Steel is positioned vertically and embedded is 6000PSI concrete. My gut feeling it to have it x-rayed to verify position and core 2 overlapping hole into the column to expose the steel. (need room for the mold) Weld the cable on & close up the hole with hydraulic mortar. PE is good with the procedure.
Anyone have a better way?
Attaching ground to steel
Moderator: Queue Moderator
-
- Batboard $upporter
- Posts: 502
- Joined: Fri Dec 19, 2003 5:33 pm
Re: Attaching ground to steel
Your PE is Okay with the 1800 deg F molten copper surrounded by reinforced concrete? How old is the concrete? with older concrete there is sometimes moisture invasion near surfaces ( the kind that corrodes rebar and such) that may be flashed to steam and further propagate cracks. How deep below the surface of the concrete is the structural steel part? Is this an outside member exposed to the elements? I think that there should be some literature on welding structural steel adjacent to reinforced concrete that may be helpful, but once again you are talking about a CadWeld mold down a hole completely surrounded by concrete.
Just some thoughts.
Just some thoughts.
Standing by...
-
- Batboard $upporter
- Posts: 502
- Joined: Fri Dec 19, 2003 5:33 pm
Re: Attaching ground to steel
The steel is in a penthouse & has not been exposed to any weather in 40+ years. Per the prints, the steel is an "I" beam (W12 x 27), in a 14" x 14" concrete column. Assuming the steel is positioned in the center, I only need to remove 1" of concrete to hit the flange.
BTW, if anyone has references to this type of connection, please point me at it.
BTW, if anyone has references to this type of connection, please point me at it.
- psapengineer
- Posts: 175
- Joined: Thu Oct 07, 2004 10:00 am
Re: Attaching ground to steel
Would arc welding a new piece of steel to the existing structure and then cad-welding to the new steel solve your problem?
-
- Batboard $upporter
- Posts: 502
- Joined: Fri Dec 19, 2003 5:33 pm
Re: Attaching ground to steel
Indeed it would! Back to the PE for his blessing. Thanks! A simple solution that I never saw.psapengineer wrote:Would arc welding a new piece of steel to the existing structure and then cad-welding to the new steel solve your problem?