Hello to all I'm new on the Bord
Need to know what might cause this problem on a saber 2
Thanks
KI4KKB
Saber squelch stays open all the time and has low audio
Moderator: Queue Moderator
Saber squelch stays open all the time and has low audio
Saber 1,2
HT600
MT500
HT600
MT500
- FireCpt809
- Posts: 1848
- Joined: Sat Jan 19, 2002 4:00 pm
- What radios do you own?: Alot..
Re: Saber squelch stays open all the time and has low audio
the squelch settings are off in the service menu in the Rss settings...
Re: Saber squelch stays open all the time and has low audio
changing the setting dose not change the problem.
1st thing i tried
open to any other suggestions
1st thing i tried
open to any other suggestions
Saber 1,2
HT600
MT500
HT600
MT500
Re: Saber squelch stays open all the time and has low audio
Normally when an FM receiver has open squelch and low audio it means that it has either low gain in the IF stages or the local oscillator is not present. The squelch won't close is because there is not enough noise being generated by the receiver to actuate the squelch circuit. This is also why the volume is low.
The service manual will tell you what levels to look for in the receive chain to isolate the part of the circuit that is causing the problem. Start by making sure the LOs are present.
There are some pretty cheap Sabers for sale by someone on the board right now if you need spare parts.
The service manual will tell you what levels to look for in the receive chain to isolate the part of the circuit that is causing the problem. Start by making sure the LOs are present.
There are some pretty cheap Sabers for sale by someone on the board right now if you need spare parts.
Re: Saber squelch stays open all the time and has low audio
I have seen this problem. Many times it is a bad solder joint on one of the ICs. I usually add flux to the chips and use a large nozzle on my chipmaster and reflow the entire upper area. About half of the time this fixes the problem.
Since we are in the process of salvaging all of our Sabers I usually just replace the entire main board. Its been over a year since I have repaired a Saber without using the shotgun method.
Since we are in the process of salvaging all of our Sabers I usually just replace the entire main board. Its been over a year since I have repaired a Saber without using the shotgun method.
Re: Saber squelch stays open all the time and has low audio
I found service manual online and it say to check the 2nd IF at u100 can you tell me if it located on the main board or in one of the modules
thanks
thanks
Saber 1,2
HT600
MT500
HT600
MT500
Re: Saber squelch stays open all the time and has low audio
U100 is on IC on the main board.KI4KKB wrote:I found service manual online and it say to check the 2nd IF at u100 can you tell me if it located on the main board or in one of the modules
thanks
Dave
Re: Saber squelch stays open all the time and has low audio
And don`t forget the good old "corrupted service settings".
Keygun
Keygun