unbricking and codeplug for MT2000

[kb3awq]

Does anyone know how to unbrick a MT2000? I have seen it done on a MT1000 by shorting something out I think.

I am searching for a codeplug also. I have posted on the codeplug site also but so far not for the correct model.

It is the top display type and here is what I am talking about and need.

For Radio Model Number:
H01KDD9AA4AN

Thanks.

[dsheli]

Well I bricked my MT2000 A7 using lab software when curiosity got the best of me. When my radio was bricked the only life it would show is a steady green LED status next to the antenna. Nothing else, I am guessing that is what your radio is doing now? Well thank fully I did the below steps outlined in the MTSX Section of Batlabs.
LAB SOFTWARE FOR BACKING UP THE RADIO! Conventional RSS will NOT back up a radio like was previously thought!

From the Main menu select F3>F4>F2 to read the radio with no unpack
From the Main menu select F3>F6 to Write S-Record

Type in a unique name ending in &guot;.bin" so as to not mistake it for anything else
Then press F6 to write the archive.
http://batlabs.com/mtsx.html
Because of this I was able to bring my radio back to life, Maybe perhaps you did the same? Good Luck

[kb3awq]

Well your are correct about the steady green light as thats all it does. I tried every file I had in there. I Must have forgot to back it up. I have for any other radio except this one... figures.. I have different code plugs but then they say the SN doesnt match and says about going into the clone section of the software and read the SN so I do that so I usually can get past that part cause I can type in the Serial number. Then the problem of the model number.... Also some of the code plugs I have some say too old and some too new. I thought I had the latest version.. Its something like 6.7 with some zeros in there. The previous version also. Just wasnt sure what to do as I cant seem to find anyone with a codeplug that matches, which seems odd with so many of them out there... Thanks again.