Remoting a Mototrbo Repeater

[johnny1225]

Im flipping a GR1225 Repeater that is remoted, to a Mototrbo Repeater in analog. The remote adapter is a M100 DC remote.
Can anyone give me what pins i need to connect the remote adapter to the Mototrbo Repeater so it is up and running.

[JohnWayne]

Here's the pinout for the 26-pin accessory connector:

1 USB_D+ USB for programming or Smart Accessory
2 USB_D-
3 V_Bus
4 USB_Ground
5 ACC_MAP_ID_2 Accessory Identifier
6 ACC_MAP_ID_1
7 Ext_SWB+ Switched Battery Voltage
8 Power Ground Ground
9 Ext_Spkr- External Speaker
10 Ext_Spkr+
11 Tx_Audio Tx Audio Input
12 Audio Ground Ground
13 Aux_Audio_Out_1 Auxiliary Audio Output (not supported in the repeater)
14 Rx_Audio Rx Audio Output (not supported in the repeater)
15 Aux_Audio_Out_2 Auxiliary Audio Output (not supported in the repeater)
16 Ground Ground
17 Prgm_In_1_(PTT) Programmable Input with prescribed function of PTT
18 Ground Ground
19 Prgm_IO_2 (Monitor) Programmable Input/Output with prescribed function Monitor
20 Prgm_IO_6 Programmable Input/Output
21 Prgm_IO_3 (Chan_Act) Programmable Input/Output with prescribed function Channel Activity
22 Prgm_IO_7 Programmable Input/Output
23 Prgm_In_4 (Emergency) Programmable Input with dedicated function for Emergency Switch
24 Prgm_IO_8 Programmable Input/Output (not supported in the repeater)
25 Prgm_1_5 (Ign_Sense) Not Used
26 Prgm_Out_9 (Ext_Alarm) Programmable Output with prescribed function of External Alarm