I have a GTR8000 that I'm looking to key using E&M (via an NXU2A). I have the GTR Base radio manual and the replacement guide as well but they leave me scratching my head a bit.
Essentially I will use the provided system connector/wireline cable connected to a 66 block and from there I will make the necessary connections on the block to connect the NXU.
Any insight in regards to where I should be looking would be appreciated!
David
GTR8000 and E&M keying
Moderator: Queue Moderator
-
kb4mdz
- Posts: 282
- Joined: Tue Oct 02, 2001 4:00 pm
- What radios do you own?: Too many for the time I have.
Re: GTR8000 and E&M keying
A quick reply until I can get back to the office & look at the manual:
GTR has Basic WIldcard features just like or similar to a Quantar; Set up so that the PTT output of the NXU-2A, connects to the Digital I/O of a opto-coupler Input, & program that for PTT (from Wireline). Similar for Receiver Unsquelched, to drive teh COS signal into the NXU-2.
GTR has Basic WIldcard features just like or similar to a Quantar; Set up so that the PTT output of the NXU-2A, connects to the Digital I/O of a opto-coupler Input, & program that for PTT (from Wireline). Similar for Receiver Unsquelched, to drive teh COS signal into the NXU-2.