R2410 analyzer problem
Moderator: Queue Moderator
R2410 analyzer problem
Monitor all works ok however the spectrum analyzer neither position works. the scope shows a straight horizontal with a test signal connected to the ant port. where do I start? thanks
Re: R2410 analyzer problem
Well the service manual on the Repeater Builder site would be the first step.
The Analyzer board is an option on the base R2200 and that is what the SM is based on so the R24X0 SA module typical shows as a supplement.
Sounds like the SA module is pretty dead or disconnected so maybe an easy fix.
The Analyzer board is an option on the base R2200 and that is what the SM is based on so the R24X0 SA module typical shows as a supplement.
Sounds like the SA module is pretty dead or disconnected so maybe an easy fix.
Re: R2410 analyzer problem
Thank you for the reply, I have viewed the sm on this board, top to bottom, The operators guide talks about the SA, however the 2200 service manual does not. Some pictures in that manual show the SA switch positions and others do not.
Is there a copy of the supplement somewhere that talks about the SA? I could not find it. I assume its on the RF module. Thanks for your help.. Al
Is there a copy of the supplement somewhere that talks about the SA? I could not find it. I assume its on the RF module. Thanks for your help.. Al