I've noticed that the rear connector of the CDM series as seen here:
https://goo.gl/images/MwLSNJ
Has a UART RX on pin 6 and a TX on pin 8. Can a simple USb>TTL adaptor be used to program this radio after connecting a ground as well? This seems to simple and I would try it but I want to get opinions before bricking a radio.
I know the USB>TTL works great for programming the Minitor series of pagers, so I was wondering if it could be used to program the CDM radios as well.
Thanks for any insight.
CDM series USB programming cable
Moderator: Queue Moderator
-
- Posts: 66
- Joined: Mon Jun 01, 2015 6:14 pm
- What radios do you own?: APX6000, APX7000, Quantar, XPR
Re: CDM series USB programming cable
The CDM series takes the same programming cable as a GM300.
http://batlabs.com/images/maxpin.gif
http://www.qsl.net/k0kn/max232-1.jpg
So the answer is yes.
http://batlabs.com/images/maxpin.gif
http://www.qsl.net/k0kn/max232-1.jpg
So the answer is yes.
Re: CDM series USB programming cable
I purchased a usb programming cable from online. it uses a prolific chip, and i have installed the drivers for it. I get the "couldnt open port, check rib, etc" error. I am using the correct port. When i try to read the radio, the radio is unresponsive, so there is some kind of connection here however i am unable to read the code plug through the CPS. I am using ver 6.12.05, it is supposedly compatible with win7. I have tried several things such as running in compatability mode for XP, running as admin, etc. I think the error is somewhere in the settings for the cable. I have tried using different port speeds and different ports but I get the same error.
Re: CDM series USB programming cable
Update: I have corrected this issue. To help anyone else, if you are using a Prolific chipset for your USB cable you must roll back the drivers to version 3.2.
See this page for more info: http://www.miklor.com/COM/UV_Drivers.php
See this page for more info: http://www.miklor.com/COM/UV_Drivers.php
-
- Posts: 66
- Joined: Mon Jun 01, 2015 6:14 pm
- What radios do you own?: APX6000, APX7000, Quantar, XPR
Re: CDM series USB programming cable
Good info, thanks. I've still been trying to get my TRENDnet TU-S9 to cooperate with the Motorola CPS. It works just fine with CHIRP, but it will not read an ASTRO25, ASTRO, or MTS2000 series radio though.Jtsou wrote:Update: I have corrected this issue. To help anyone else, if you are using a Prolific chipset for your USB cable you must roll back the drivers to version 3.2.
See this page for more info: http://www.miklor.com/COM/UV_Drivers.php