Aeroflex 3500a RSSI and Freq Domain Failed Diags

This forum exists for the purposes for discussing service monitors (This includes but is not limited to Motorola, HP, Aeroflex, GD, etc). Additional topics allowed include test procedures, interpretation of test results, where to find information about specific tests, antenna VSWR, return loss testing, duplexer and filter alignment, etc.

Moderator: Queue Moderator

Post Reply
des
New User
Posts: 2
Joined: Sun Mar 24, 2013 8:52 pm

Aeroflex 3500a RSSI and Freq Domain Failed Diags

Post by des »

Hi!

I recently got an Aeroflex 3500a, and ran the diagnostics and had the RSSI and Frequency domain diags fail. Has anyone seen this as a calibration issue, or an actual faulty part in the 3500a? The service manual only points to the multi-function pcb assy for both issues.

Thanks!
Top
des
New User
Posts: 2
Joined: Sun Mar 24, 2013 8:52 pm

Re: Aeroflex 3500a RSSI and Freq Domain Failed Diags

Post by des »

Fixed it! In the Rx cal editor settings, the normalize (dB) was set to +33dB, i set it to 11dB and that cleared up both failures. I will look at getting it calibrated properly in the future.
Top
Post Reply

Return to “Test Equipment & RF Equipment Alignment”