I was programming a CDM1250 when something occured during the programming and (synth unlock) showed up on the readout and I am also getting (ram tst error) & (error: Timeout) showing up on the readout every once in a while as well.Can anyone help me rectify this problem???
Ron-NJ
CDM1250 (Synth Unlock)
Moderator: Queue Moderator
You didn't by any chance try writing someone else's codeplug into the radio did you?
The 'RAM TST ERROR', means that there is a 'RAM test failure'. For this error, if you turn the radio off and turn back on again it should go away, if it doesn't, then the manual says to replace RAM (U0122).
When you get a 'SYNTH UNLOCK', usually means that the radio is out of the frequency bandsplit that is applicable to that radio.
Hopefully you saved your original codeplug, try writing the original codeplug back in the radio.
The 'RAM TST ERROR', means that there is a 'RAM test failure'. For this error, if you turn the radio off and turn back on again it should go away, if it doesn't, then the manual says to replace RAM (U0122).
When you get a 'SYNTH UNLOCK', usually means that the radio is out of the frequency bandsplit that is applicable to that radio.
Hopefully you saved your original codeplug, try writing the original codeplug back in the radio.
-
Bill Rogers
- Posts: 81
- Joined: Sun Sep 09, 2001 4:00 pm