Hey guys, I have a Maxtrac B7, and i programmed it, and when i turned it on, the display was blank, and it doesn't do anything. also it won't reprogram! I keep getting error code. anything i can do? or is it is wasted?
Thanks!
Jordan
Maxtrac 800 MHz B7
Moderator: Queue Moderator
-
- Posts: 2
- Joined: Tue Dec 25, 2001 4:00 pm
-
- Posts: 2
- Joined: Tue Dec 25, 2001 4:00 pm
Ok, which error tone? In trunking maxtracs you can get 6 different error tones upon wakeup. It can be a low pitched tone (163Hz) for 5 seconds after turn on, 450Hz tone for 1 second followed by illegal function tone, or a contiuous pattern of 1,2,3, or 5 beeps (1000Hz) followed by a pause after turn on.
The first one can usually be cleared by retuning any value in the "service alignment", programming the softpot and exiting properly out of the alignment screens. The second can usually be cleared by dumping a known good backup codeplug into the radio. The other 4 are more serious, and may require a new logic board, or at the very least have someone experienced with the Maxtrac have a look at it, like your local MSS or Monty.
Also, what type of computer & operating system you were using?
Todd
<font size=-1>[ This Message was edited by: wavetar on 2002-01-11 15:27 ]</font>
The first one can usually be cleared by retuning any value in the "service alignment", programming the softpot and exiting properly out of the alignment screens. The second can usually be cleared by dumping a known good backup codeplug into the radio. The other 4 are more serious, and may require a new logic board, or at the very least have someone experienced with the Maxtrac have a look at it, like your local MSS or Monty.
Also, what type of computer & operating system you were using?
Todd
<font size=-1>[ This Message was edited by: wavetar on 2002-01-11 15:27 ]</font>