Batboard

Hello Everyone,

Can the MTR3000 be programmed remotely with the advanced software package via an Ethernet interface on the Station?

Also, via the same Ethernet interface, can you see forward and reflected power? How about RSSI for Rx signal level?

Thanks in advance, BobJ

I have the same question regarding remote programming of the MTR3000. How is this achieved? I thought it might be RDAC, but don't see the feature.

You need the Programming over IP EID. HKVN4047A. MSRP $250. I sell them for $165.

ESCOMM,

Thank You. We now have the Radio, the HKVN4047A IP Key, and CPS on order from mother M.

Again, thanks for your time and experience.

Best Regards, Bob