XPR4350 Quik-Call II Problem

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
Posts: 110
Joined: Thu Jan 13, 2005 7:01 pm

XPR4350 Quik-Call II Problem

Post by yagermeister »

I have several channels set for NOAA Weather Radio. I program them for Quik-Call II, A-B, Long B, with both A and B set for 1050 Hz. This has always worked on Maxtracs, and I dont include them on any scan lists. In the zone programming, RX is set for CSQ and Quik-Call II Signaling System. If I put the radio on one of these channels and leave scan off the radio unmutes anyway. I can’t figure out why the radio won’t stat silent unless it receives a weather alert. I’m using CPS R16 to program the radio. Can anyone tell me why the radio is doing this?
Thank You
Post Reply

Return to “Radio Programming”