Batboard

I am trying to set up a GTX Mobile to scan conventional channels. Nothing seems to work. What am I missing ?

Thanks, Dick, W1KSZ

Is scan enabled in RSS?
Is the mic off hook switch grounded?

I tried grounding the rear of the mike, no luck.
I think that scan is enabled but the RSS is none too clear and I
have problems translating MOTOspeak, and I have the GTX RSS Manual.

Thanks, Dick, W1KSZ

w1ksz wrote:I tried grounding the rear of the mike, no luck.
I think that scan is enabled but the RSS is none too clear and I
have problems translating MOTOspeak, and I have the GTX RSS Manual.

Thanks, Dick, W1KSZ

Does the scan icon in the display turn on & off when you push the scan button ?

No, it just beeps at me.
Where in the RSS is the Scan enabled ?

Thanks, Dick, W1KSZ

I got two of the three radios to scan properly. The third will not. Suddenly dawned on me to check the Model numbers and sure enough, the problem radio is a different model number.
Thats why the Scan table looks different when I read the Code Plug.
And I cannot clone the Code Plug to a different Model Number.
So, 2 out of 3 ain't bad !@!!

Regards, Dick, W1KSZ

I have the same problem. When I enable scan it reverts to the only mode left for trunking and would allow scanning of personalities. I understand you must leave one mode as trunked.

What model number did you have problems with and which ones worked?

Thanks,
Ken

The problem radio is no more. A local who doesn't want scan capability took it.

Thanks, Dick, W1KSZ