Page 1 of 1
HT1000 2.5mhz Bandwidth
Posted: Fri Jun 13, 2003 1:24 pm
by RadioMan1101
Our PD has installed a repeater system and the frequencies are in the 2.5mhz bandwidth. M1225's program up fine but the HT1000's wont. I believe it's because of the version of RSS we have (2.00.00). It keeps wanting to "round off" when you try to enter 153.7925mhz. I guess my question is do we need to get a newer version of RSS?
Posted: Fri Jun 13, 2003 5:20 pm
by The Pager Geek
A newer version RSS will be needed, but I'm also guessing that your radios are A or B version. They won't do the "splinter" 2.5KHz channels. Only C or D versions will. They will need to be upgraded to D version by changing the controllers out.
Latest HT1000 (I think) is 3.03.00
tpg
Posted: Thu Jun 19, 2003 3:19 pm
by rrfd43
yes, as the Geek says...I had the same problem. I could only get the "D" versions to take this new channel. The "d" versions have a more selective rf end. There should be a thread on here about this same issue that I started some time ago. Nand gave the answer in tecnical terms. I was able to round up to the nearest freq. to use them to recieve and they work "OK".
Posted: Thu Jun 19, 2003 5:13 pm
by mancow
Do you guys know of a way to tell if the RF boards are 2.5 khz capable by looking at them. Other than a part #. I have a few and would like to find out.
mancow
Posted: Thu Jun 19, 2003 6:00 pm
by rrfd43
I can't help you there, maybe the Geek can. I am told just enough to be dangerous.....Not to give him a hard time (he was great) nand had a lot of info on these....
Posted: Fri Jun 20, 2003 11:35 am
by RadioMan1101
Thanx, trying to decipher the model number info now. Most of the portables are newer but some are a little beat up and of course someone put the inventory tags over the model and serial number! Now, if I can only find my glasses!
Posted: Sun Jun 22, 2003 11:13 am
by rrfd43
read em with rss and the model # will be at the top....