Maxtrac 820

Burner · Post by **Burner** » Tue Jan 08, 2002 9:34 pm

Not up on programming Trunking radios, I looked at this radio on RSS but no place to enter freq's?? How does this work

RESCUE161 · Post by **RESCUE161** » Thu Jan 17, 2002 5:51 am

I'm having the same problem???
did you figure it out?

eacradio · Post by **eacradio** » Thu Jan 17, 2002 12:09 pm

Maxtrac 820 is a trunking radio; the only freqs you enter are the control channels that are entered in the system info screen. You also need a system key to do this.

Post by **wavetar** » Thu Jan 17, 2002 2:17 pm

If all you see after reading the radio is the "F2 - Radio Wide Configuration: Time Out Timer" under the "Change/Create/View" menu, then you are both trying to read a Trunking Maxtrac with Conventional Maxtrac RSS (RVN-4019). You need to use the separate Trunking Maxtrac RSS, part# RVN-4043.

Todd

RESCUE161 · Post by **RESCUE161** » Fri Jan 18, 2002 6:23 am

Well, that leaves me out, I only have Maxtrac Lab RSS...
oh well...

Post by **wavetar** » Fri Jan 18, 2002 3:24 pm

You are correct, there are separate LAB RSS for the trunked & conventional Maxtracs as well.

Burner · Post by **Burner** » Fri Jan 18, 2002 8:40 pm

Same with me all I have is Lab RSS, poop