Posted: Thu Jan 17, 2002 5:37 am
I have a maxtrac that I think has a missing code plug. I'm not too familiar with it, but when I 'read' the codeplug, the lab software that i'm using will only allow me to change the timeout timer on the 'change/view codeplug' option. This leads me to my two part qeustion: 1) If the codeplug is lost, can someone e-mail me an 800 MHz trunking codeplug? 2) What kind of firmware changes need to be made after blanking the board to make it a conventional radio?
thank you,
scott...
thank you,
scott...