HT1250 MDC PTT-ID

PriorityOne · Post by **PriorityOne** » Sun Apr 11, 2004 7:29 pm

My HT1250 does not seem to be encoding MDC, probably because I'm not doing something correctly but I copied the settings from a radio that works fine. It is audibly there, trailing the TX, however if I look at my other 1250 there is no ID there from the TX'ing radio. The radio recieves and decodes other MDC users just not my 1250. Any ideas?

Post by **HumHead** » Sun Apr 11, 2004 8:02 pm

Are you using the same ID in both radios?

The radio will ignore its own ID.

sc9020 · Post by **sc9020** » Mon Apr 12, 2004 11:36 am

how can i get my 1250 to read other radio mdc id ?

RKG · Post by **RKG** » Mon Apr 12, 2004 11:55 am

I had thought that caller ID worked only on pre-ID, not post-ID.

J.Sanor · Post by **J.Sanor** » Mon Apr 12, 2004 12:19 pm

works on both pre and post. I have my HT1250's and CDM mobiles displaying ID's on both pre and post transmitions

PriorityOne · Post by **PriorityOne** » Mon Apr 12, 2004 1:14 pm

that must be it... the ID's are the same so the radio is ignoring it. Thanks!

BTW, sc9020 you have to enable the "Display Decode ID" in the MDC signalling menu in the software, and also select MDC as your recieving signalling system under each channel you want it to decode for.

sc9020 · Post by **sc9020** » Tue Apr 13, 2004 4:22 am

Hey THANKS

I will try that when I get home