Page 1 of 1
OT: How to build your own VX-10 Programming cable
Posted: Wed May 19, 2004 6:17 am
by dog pecker gnat
First off, if all you're going to do is tell me "Why don't you just go buy one," don't bother.
I would like to know how to build the programming cable for a vertex VX-10 portable. I got this thing and I just want to experiment with it. If anyone can help me out, I would greatly appreciate it.
thanks!
DPG
Posted: Wed May 19, 2004 7:53 am
by ANB_Medic
Unfortunately, it's not just a cable. There is a RIB-like interface that comes housed in the connector.
There was a thread about converting a /\/\ RIB to work with Vertex. You may want to check that out. Otherwise, you need to come up with a bunch of cash. Mine was over $200.00 CDN by the time I got my hands on it.
Todd
Posted: Wed May 19, 2004 11:43 am
by willbartlett
Judging from the schematic I looked at. I think if you used the Data and ground lines on a RIB with the connector wired for a GP300, I would think it might work. If I get a chance, I'll take a stab at it. I have successfully used the RIB to talk to an Icom F40LT and a T90 in the last week.
Will
Posted: Sun May 23, 2004 9:20 am
by dog pecker gnat
did you have any luck with the schematics? would one just wire a stereo mic jack into a plug to hook up to the rib?
Posted: Sun May 23, 2004 9:27 am
by willbartlett
Sorry to say I haven't. the limiting factor is not having the 4 conductor connector handy. I thought I had one but apparently not. I do have one of the adms cables so I haven't ever had a real motivation to build one from scratch. The Ham cable, btw, does work fine with the commercial stuff, vx-10, 210, 400, etc. If I do dig the connector up, I'll be sure to give it a try.
Posted: Sun May 23, 2004 9:58 am
by dog pecker gnat
well i lucked up on this cable that someone gave me, but i dont know what the deal is, i guess it doesnt work because it wont allow me to read the radio, it just locks up.
Posted: Sun May 23, 2004 7:09 pm
by RESCUEMAN433
go to hamradio.com buy the adms progamming software and cable for the vx-110 radio and now you have the cable, do not use the software though. It's like 30 bucks
Posted: Wed May 26, 2004 11:14 pm
by redbeard
Here's a site with schematics for making your own cable. It also shows where to get the 4-conductor 'quadraphonic' plugs if you need one. I'm not sure what the commercial version of this cable costs, but the ham cable is availiable from RT Systems by itself (CT-29D $29) so you don't have to waste money on the software for a ham rig you don't have.
http://www.qsl.net/kc8unj/interface.html
Another site:
http://home.comcast.net/~sllewd/vx7rhardware.htm
RT Systems:
http://www.rtsars.com/