HT750 Quick Call Question

nanavati · Post by **nanavati** » Sat Jul 31, 2004 4:52 pm

I've tried to lookup some information regarding my problem, but I guess I'm the only unlucky one to have it.

I have this VHF HT750 (4ch) Model#AAH25KDC9AA2AN (ver r5.03.02r), and I'm trying to setup Quick-Call II decode on one of the personalities. The problem is that under the signalling tab, there is no option for Quick-Call; I only see MDC -1 and MDC -2.

Do I have a "bad-codeplug" or does this radio not support QCII?

Thanks in advance!

Vern · Post by **Vern** » Sat Jul 31, 2004 5:07 pm

I believe I've read on the board, that the 750 doesn't do QCII,. There was a thread abut this recently, a search may turn up something more definite. The 1250 and 1550? do support paging as I recall.

Vern
KE4MAO

Ben · Post by **Ben** » Sat Jul 31, 2004 5:25 pm

I know the 1550 support QQII and I think the 1250 do to.

KC8NIY · Post by **KC8NIY** » Sat Jul 31, 2004 5:28 pm

.....as does the HT750. I'm just going by the specs, and don't know enough about CPS to comment further. Someone else here will have to take up that duty.

Jay911 · Post by **Jay911** » Sat Jul 31, 2004 6:09 pm

I've tried to accomplish this on some HT750s without success for a few years. I DO show the QCII options, and can program it, but I get no alerts when the tones are sent across the channel--while other radios pick up the alert just fine.

I think it might be a firmware issue.

nanavati · Post by **nanavati** » Sat Jul 31, 2004 11:19 pm

I'm starting to think that there is a problem with the codeplug. Does anyone have a codeplug that I could use to put into this radio?

HT750 Quick Call Question

HT750 Quick Call Question

QC II