Page 1 of 1
HT1250 EEPRM CS ERROR
Posted: Tue Nov 02, 2004 12:03 pm
by central150
I know this error is a checksum error. I did some searching and couldn't find a solid answer if this is something that I could fix or would have to send out to the Depot. I was programming, then got the error beep when the radio powered back up, and was unable to read the codeplug. I was able to write to it, but it would still give the error. help me..
-Tony
Posted: Tue Nov 02, 2004 1:26 pm
by ANB_Medic
I had the same problem a while back.
If memory serves, I just loaded a c/p from a good radio and cloned it over.
Give it a shot. If it doesn't work, let me know and I'll pull up my notes.
Todd
Posted: Tue Nov 02, 2004 1:28 pm
by central150
Tried that already... used the codeplug that I had saved, and it didnt work.
-Tony
Posted: Tue Nov 02, 2004 1:31 pm
by ANB_Medic
Yeah, I had that issue as well. You're going to have to find another radio, read the plug and then clone it in to the brick. Don't know why it doesn't take the original, but it won't.
Todd
Posted: Tue Nov 02, 2004 3:20 pm
by central150
I tried that too...that didnt work either.
Posted: Tue Nov 02, 2004 3:51 pm
by ANB_Medic
Hmm... Not sure what to tell you then... It worked for me. See the following post...
http://batboard.batlabs.com/viewtopic.p ... hlight=doh
Sorry I couldn't be of more help.
Todd
Posted: Tue Nov 02, 2004 3:51 pm
by ltec123
Which version software are you using?
I used 6.04 then changed to 6.05 and works fine since...
LT
Posted: Tue Nov 02, 2004 3:54 pm
by central150
I am using 6.04.... maybe i need upgraded cps
Posted: Tue Nov 02, 2004 3:59 pm
by central150
or maybe a good codeplug...my model number is AAH25KD9AA6...
Posted: Tue Nov 02, 2004 5:32 pm
by HumHead
Sometimes a firmware upgrade will do the trick as well.
If you can find a radio, of the same model, that is a candidate for a firmware upgrade, you can start the upgrade compatability check with that radio and then switch to the hosed radio for the actual upgrade. (i.e. Switch radios once it tells you to put the radio into bootstrap mode.)
Posted: Tue Nov 02, 2004 5:34 pm
by central150
I dont believe I have the hardware for that kind of trick. I thought that the radio I used to clone was the same model number but it wasn't. I NEED HELP!! I NEED CODEPLUG!
-Tony
Posted: Tue Nov 02, 2004 7:29 pm
by ANB_Medic
What's your full model number and firware version?
T.
Posted: Tue Nov 02, 2004 7:37 pm
by central150
AAH25KDH9AA6AN firmware version is 2.03
Posted: Wed Nov 03, 2004 4:29 pm
by central150
I got a good codeplug from the same type of radio, programmed it into mine and I still get the error. This freaking error is killing me.
-Tony
Posted: Thu Nov 04, 2004 6:03 pm
by lovemoto
Hi, I heard replacing the EEPROM will solve this problem for GP328.