Original RLN4008BRIB power & operating instructions

indigo · Post by **indigo** » Fri Nov 12, 2004 3:45 pm

Can someone verify or comment on the following regarding the RLN4008?

1. Can someone verify 7.5 to 15 volts DC input is suitable for this RIB, and what amperage is required/recommended ?

2. I will try searching again here & elsewhere, but can anyone direct me to the Operation Instructions for the Moto RIB?

Thanks

JAYMZ · Post by **JAYMZ** » Fri Nov 12, 2004 5:04 pm

9 VDC at 600 ma if I'm not mistaken is what the power supply for the RIB is rated for.

jackhackett · Post by **jackhackett** » Fri Nov 12, 2004 6:28 pm

Rib supplies were discussed at length a while back, here's the topic:

http://batboard.batlabs.com/viewtopic.php?t=26020

My Mouser supply is still holding up fine a year later. Just checked - still available, $4.25 each