Page 1 of 1
mts2000 sidetone (no beep)
Posted: Sun Feb 19, 2006 9:55 pm
by caprice96
i have mts2000 and i have one of mt channels set to have a pre-id (mdc1200) and i enabled the sidetone feature for the signaling system but when i press the ptt button i dont hear the beep?
Posted: Sun Feb 19, 2006 10:05 pm
by Rayjk110
I'm not too sure on how familiar you are with the MTS2000 RSS, but, here are a few things to check:
MDC ID is set to PRE under signalling
Make sure the channel you want to program the ID on has signalling enabled
Make sure that you have signalling enabled so that you get the prekey ID 'tone' enabled. For some reason it has the option to have the option turned off, and this may be the case.
Posted: Sun Feb 19, 2006 10:45 pm
by muggsy09
Also be sure that the alert tones are all enabled, and the alert tone volume is set correctly and not disabled.
~Muggsy~
Posted: Tue Feb 21, 2006 2:41 pm
by caprice96
I have tried all of those things and still nothing.
Posted: Wed Feb 22, 2006 2:21 pm
by RKG
Using a receiver on the input, verify that your radio is sending MDC ID. Maybe it isn't capable of that. Also be sure the programmed ID is a valid one (no "F"s).
Posted: Wed Feb 22, 2006 2:48 pm
by caprice96
it decodes on my cdm1550 and the id is all numbers(6201)
Posted: Wed Feb 22, 2006 2:53 pm
by RKG
Then I'm out of ideas; would have to see the radio.
Posted: Thu Feb 23, 2006 2:43 pm
by caprice96
thanks RKG, anyone else have any ideas?