GM300 - Hi/Lo Power

gdsteele · Post by **gdsteele** » Sun Jun 04, 2006 5:54 pm

Is the GM300 output just one power setting for the radio? In other words, can you set channels to be 'high' or 'low' power? If so, where in the RSS do you set that? I have adjusted the power in the service mode, but don't see any other mention of output power.

SPEAKER MIC · Post by **SPEAKER MIC** » Sun Jun 04, 2006 8:22 pm

i believe its a blanket setting, i just set one up and i was looking for the same thing, however, i found out that it can send a mdc chirp out for a low battery...

kcbooboo · Post by **kcbooboo** » Mon Jun 05, 2006 3:12 am

Yes, GM300, like MaxTrac and Radius mobiles, have only one power setting, and it affects all modes. You adjust it through the service menu. Typically, you don't want to set it lower than about 1/2 of the radio's rated output power.

Bob M.