Page 1 of 1
cdm trouble
Posted: Tue Aug 08, 2006 7:28 pm
by jmr3865
I am having trouble with a few cdm's. When scanning channel 1 wide band and channel 2, narrowband, i have to turn the volume up on channel 2 in order to hear it. than channel 1 comes in two loud. I am constantly adjusting it. Any sugg? firmware?
Posted: Tue Aug 08, 2006 7:36 pm
by jim
Someone elses levels aren't right if your spacing is properly set.
Posted: Wed Aug 09, 2006 12:51 am
by J.Sanor
Try turning on the Companding feature for channel 2. This is supposed to improve the audio on narrow band channels
Posted: Wed Aug 09, 2006 7:47 am
by jmr3865
i am using companding. 159.2175 is 12.5 right?
Posted: Wed Aug 09, 2006 8:26 am
by HLA
companding is only going to work right if everyone else has theirs on too.
Posted: Wed Aug 09, 2006 9:21 pm
by thebigphish
do you have (that gawdawwful) lowlevel expansion or the AGC on?
Posted: Thu Aug 10, 2006 3:10 am
by bellersley
What is LLE supposed to do anyway? Anytime I have enabled it, the audio is terrible! And when I turn on AGC, it takes a second for the audio to come up it volume... Useless!
Posted: Fri Aug 11, 2006 10:07 am
by jim
Turn off all "audio enhancers" that destroy audio quality.