Batboard

2 questions-

programming a saber 3 with some channels on carrier squelch RX-
is there a way to adjust the squelch threshold?

in oper selectable scan, is there a way to clear the scan list?

The squelch is adjusted in the alignment and service portion of
the RSS.

Yes there is a way to clear the list.
Do the opposite of entering the channels and you will end
up with an empty list. In other words just delete them one by one.

Phrawg

thanx for your help.


Yes there is a way to clear the list.
Do the opposite of entering the channels and you will end
up with an empty list. In other words just delete them one by one.

exactly how do i do this.

Go to the actual scan list, the one with the blanks that are
separated by a forward slash. Hit "Delete" as you move
across each zone/channel selection and you'll end up with
just the blank line with no numbers showing.

Then go to the individual channels in the zones and delete
the scan assignments, though this really isn't necessary
once you've killed the scan list(s).