Page 1 of 1
VHF MCX1000 Alignment
Posted: Wed Dec 20, 2006 2:55 pm
by w4rez
Is there a quick and dirty alignment procedure for the MCX1000? This one is tuned for 165-170 MHz and is therefore nearly deaf on 2m where I need it to be able to hear.
Posted: Thu Dec 21, 2006 10:37 pm
by EPC_1111
I have the service manuals, Ill look up the procedure for you. What are you trying to tune it to?
VHF MCX1000 Alignment
Posted: Fri Dec 22, 2006 3:35 pm
by Jatla
I assume that you are looking for a work around the needing of an RF millivoltmeter and the right probe adapter? I am not sure there is a good way to get past this, unless a try and try again adjusting approach of the slugs with a signal generator into the antenna connector and comparing the sensitivity...this may be a very difficult road to hoe.