Batboard

I'm looking for the part number for just the back plastic housing for the CDM control head...when used in a remote configuration. I'm assuming it comes with the small PC board in it also.

If I had the complete kit part number, I might be able to get Parts ID to break it down for me...but I don't have that either....

I had the very same parts you are looking for. I gave them away for free because i broke one of them(mashed the pins) So i had to get a new new remote kit.
They are not that expensive, So it was more of a lesson to me...

RLN4802A i think this what you need... as always please check number before you order

Just an update to this thread, I went ahead and order the kit, and inside the kit is the paperwork breaking down each part of the kit. Not sure if each part can be ordered individually...but I'm listing them here in case anybody else runs into this same situation...only needed one part of the kit. I did a search for some of these on MOL, and some of them do show for me.

Below is what comes in the kit per the RLN4802A Documentation

0305760W02
Wingscrews

0764275B01
Remote Bracket

1564268B01
Remote Back Housing A

1564269B01
Remote Back Housing B/C

3202620Y01
O-Ring Control Head

GLN7362B
Remote PCB board

8486127B01
Flex (Two per kit)

1564270B01
Remote Front Housing

6686119B01
Dismantling Tool

GMLN4086A
Remote Mount PCB front board

Thanks for the part numbers!
these will come in handy if i need to order parts... Hopefully the parts can be ordered ..
thanks for the update
Gig