Hi guys,
I have a standard Saber III VHF that is 100% fine except: when the radio is in scan, it will receive normally, scan works normally, but the display will continue to read "scanning" even when the radio is stopped on a channel. (in scan mode and receiving)
Any ideas?
Thanks,
Rich
Bizarre Saber scan problem
Moderator: Queue Moderator
- Dorpmuller
- Posts: 75
- Joined: Tue Dec 05, 2006 11:41 pm
normal
I will have to second the opinion that problem is actually normal. When I still had them I believe all of my saber's did this.
- Tom in D.C.
- Posts: 3859
- Joined: Tue Sep 04, 2001 4:00 pm
- What radios do you own?: Progreso soup can with CRT
Saber scan display...
That's the way they work. It's nuts but it's the
way they are. Astro Sabers, by comparison, tell
you WHERE they've stopped to scan, which is
pretty nice.
way they are. Astro Sabers, by comparison, tell
you WHERE they've stopped to scan, which is
pretty nice.
Tom in D.C.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
- FireCpt809
- Posts: 1846
- Joined: Sat Jan 19, 2002 4:00 pm
- What radios do you own?: Alot..
- Dorpmuller
- Posts: 75
- Joined: Tue Dec 05, 2006 11:41 pm
My saber operates different than everyone elses.
I have a VHF secure III with 5 D core that usually shows the stopped channel but sometimes and this is only about 2 or 3 % of the time, when I start scan it shows scanning when stopped on a channel.
If I stop and then restart scan then it reverts back to showing the correct channel alphanumeric tag that it stops on.
This only occurs in mode scan, programmable scan always shows the correct stopped channel during scan.
Mike
I have a VHF secure III with 5 D core that usually shows the stopped channel but sometimes and this is only about 2 or 3 % of the time, when I start scan it shows scanning when stopped on a channel.
If I stop and then restart scan then it reverts back to showing the correct channel alphanumeric tag that it stops on.
This only occurs in mode scan, programmable scan always shows the correct stopped channel during scan.
Mike