Batboard

Ok, so here's the setup.

I'd like to know what is the best way to connect a mike phone to a two-way radio repeater. Inbetween the mike and the repeater will be a controller that will only allow audio to pass when it receives the proper DTMF "link On" code. The controller will be responsible to key up the repeater and mike phone, depending on which one is receiving at the time.

What is out there to interface this, what has been used in the past, what works the best. Any tips, opinions, etc.. are much appreciated.

Unfortunately the only possible way for this system to work is to interface a Mike Phone to a VHF Repeater.

Thanks in advance!!

Jamie

Vercomm wrote:I'd like to know what is the best way to connect a mike phone to a two-way radio repeater. In between the mike and the repeater will be a controller that will only allow audio to pass when it receives the proper DTMF "link On" code. The controller will be responsible to key up the repeater and mike phone, depending on which one is receiving at the time.

If what you mean is a Telus Mike (IDEN) phone:

Link Communications TCB-1
http://www.link-comm.com/ppage.php?cid=1&scid=1

Telex-Vega NI-223
http://www.telex.com/radiodispatch/Prod ... oductID=81

As per the board's rules, please do not post the same topic in multiple forums.

Check out codespear from Federal Signal...
http://www.codespear.com/RadioInterope ... _4674.aspx