Posted: Thu Nov 01, 2001 3:17 pm
Hi,
after programming two MX2000 VHF (only changing one frequency) the TX works with about only a few milliwatts. But the power setting is "Std. RF Power per Radio high" as before.
While RSS writes the data into the radio the display shows "ERR 0 81", may this be the reason? I'm using RSS R02.00.00.
Does anybody know this strange behavior?
after programming two MX2000 VHF (only changing one frequency) the TX works with about only a few milliwatts. But the power setting is "Std. RF Power per Radio high" as before.
While RSS writes the data into the radio the display shows "ERR 0 81", may this be the reason? I'm using RSS R02.00.00.
Does anybody know this strange behavior?