Page 1 of 1
09/10 Error
Posted: Fri Apr 24, 2009 5:22 pm
by firemedic4
I took a xtl5000 w5 and made it a remote mount 05 radio. I powered it on and now getting The 09/10 error message. Anyone have a quick fix for the problem ? Thanks
Re: 09/10 Error
Posted: Fri Apr 24, 2009 7:12 pm
by tvsjr
09/10 is secure hardware missing or failed. Turn secure hardware equipped off.
Re: 09/10 Error
Posted: Fri Apr 24, 2009 7:24 pm
by firemedic4
Okay will do. Secure was working fine till i did the head change.
Re: 09/10 Error
Posted: Fri Apr 24, 2009 7:37 pm
by akardam
You probably need the newer part number for the secure carrier board, which is compatible with the O5 head. The original part number is not.
Re: 09/10 Error
Posted: Mon Apr 27, 2009 2:07 am
by rc50won
akardam wrote:You probably need the newer part number for the secure carrier board, which is compatible with the O5 head. The original part number is not.
Would that part number be MHLN6918B?
Marshall
Re: 09/10 Error
Posted: Mon Apr 27, 2009 2:15 pm
by firemedic4
Would it work if i did a firmware upgrade on the secure module ?
Re: 09/10 Error
Posted: Mon Apr 27, 2009 4:20 pm
by akardam
It has nothing to do with the firmware in the module and everything to do with a hardware incompatability between the old carrier boards and the new heads. You need one of the following:
MHLN6918B - XTL Encryption Interface 3 Day - O5 Head Comptatable
HLN6919B - XTL Encryption Interface 30 Second - O5 Head Compatible
Re: 09/10 Error
Posted: Thu May 14, 2009 11:07 am
by firemedic4
Does the Board go in the head or the Radio ? Thanks Bob
Re: 09/10 Error
Posted: Thu May 14, 2009 3:12 pm
by jmr061
It is in the radio directly behind the interconnect housing under a shield.
Jason
Re: 09/10 Error
Posted: Fri May 29, 2009 6:41 pm
by jmr061
This radio was sent to me for repair as it was coming up Error 9/10 and Maint. Mode.
I found that the secure module itself had a "tang" broke off on one of the copper tabs that gets grounded when the shield goes over the top. This acts much like the popple on the MTS2000 series secure board. I was able to jumper this and now secure works fine.
A control head sync took care of the maint. mode issue. It was interesting though, the CPS told me it couldn't detect the firmware version in the radio so it told me to type it in, which I did do since I knew what it was as I had it working with an O3 head on and was able to get the info.
Radio is all good now.
Jason